The solution from Bungie didn't worked for me but this one yes hope this will help : source : https://www.reddit.com/r/DestinyTechSupport/comments/709y9d/fix_cabbage_error_technicolor_tg789_v3/ [b]English[/b] I'am from Chile, my ISP is Movistar and my router is a Technicolor TG789 V3, this is a series of steps to fix error cabbage/lettuce in Destiny 2: Disconnect all dispositives from router (phone, pc, consoles, etc.) this is yellow ports. In the pc modify network settings with this values: IP 192.168.1.252 Subnet Mask 255.255.255.0. Connect the pc into the router in port 1. Open cmd/console and type: telnet 192.168.1.1, the user is Administrator and password is Bhs!tg789vn!v3!!. Type env set var SESSIONTIMEOUT value 0, this is for the router don't kicked us out after 10-20 sec. Type connection bindlist, this show us all the ports was bind and in the final of the list must be the ports UDP 3074 and UDP 3478-3479, this are the ports that needs to be unbind. Type connection unbind application=CONE(UDP) port=3074, press enter. Type connection unbind application=CONE(UDP) port=3478-3479, press enter. Type saveall, press enter and wait until the command line show up again. Close cmd/console, restart the configuration on network settings in the pc and connect all again. The technical information about problem in the ports was post here. Steps for connection to the router was seen in this posts here and here [b]Español[/b] Soy de Chile y mi ISP es Movistar tengo un router Technicolor TG789 V3, los siguientes pasos son para solucionar los errores cabbage/lettuce en Destiny 2: Desconectar todos los dispositivos del router (teléfono, pc, consola, etc.), es decir lo que esté en los puertos amarillos. En el pc configurar los parámetros de la tarjeta de red con los siguientes valores: IP 192.168.1.252 Máscara de Subred 255.255.255.0. Conectar la pc al router en el puerto 1. Abrir cmd/terminal y teclear: telnet 192.168.1.1, el usuario es Administrator y la clave es Bhs!tg789vn!v3!!. Teclear env set var SESSIONTIMEOUT value 0 esto es para que el router no nos desconecte después de 10-20 sec. Teclear connection bindlist, esto nos muestra todos los puertos que están configurados al final de la lista deben estár los puertos UDP 3074 and UDP 3478-3479, estos son los puertos a los que necesitamos hacerle unbind. Tecleamos connection unbind application=CONE(UDP) port=3074, presionamos enter. Tecleamos connection unbind application=CONE(UDP) port=3478-3479, presionamos enter. Tecleamos saveall, presionamos enter y esperamos hasta que se nos muestre de nuevo la linea de comandos. Cerramos cmd/terminal, restauramos las configuraciones de la tarjeta de red y conectamos todo otra vez.